Wuhan Guide IR136 Instrukcja Użytkownika Pobierz pdf (Strona 3)

Precautions

All User Manuals and leaflets should be read thoroughly before proceeding with operation of the

equipment

It is also advisable that all User Manuals and Instruction Leaflets supplied are kept readily available,

for reference when the equipment is in general use

The following precautions must be adhered to at all times and must be considered in addition to any

advised precautions issued at the relevant worksite or work area

• Do not supply power to IR136 Thermal Camera beyond the followed requirement:

DC +24V（±1V）

AC 110V-240V, 50-60 Hz, power rate≥50W

• You will use PC, monitor, power and etc with IR136 Thermal Camera, so it is highly

recommended to connect all the electric systems with ground

• It is highly recommended to use IR136 Thermal Camera statically although it is static

protected. By this, to avoid any damage to the precise electronics inside the camera

• Do not frequently power on/off the camera. Time between on and off should be not less

than 30 sec.

• Do not pull in/out power cord, video cable, control cable etc. when the camera is on; And

highly recommended to cut off power of all the connected electric systems like monitor

when pulling in/out all the cables.

• Do not direct the IR136 Thermal Camera at very high intensity radiation sources such as the

sun, carbon dioxide lasers or arc welders etc

• Do follow the environmental conditions as follows:

Storage Temp: -45 ℃ ～ 65℃

Work Temp: -40 ℃ ～ 55 ℃

Vibration: 5-500 Hz, 12.7mm peak

Shock: 20G, 11ms

1 2 3 4 5 6 7 8 ... 23 24

Brak uwag

Wuhan Guide IR136 Instrukcja Użytkownika Strona 3